FOOD SOURCE 1a Unapproved source PUBLIC HEALTH SIGNIFICANCE All foods used in retail food establishments must be obtained from commercial suppliers that are inspected by health authorities (state or local health departments, USDA, FDA). Foods prepared in private homes are frequently implicated in foodborne outbreaks. Non-commercial kitchens have limited capacity for maintaining food at proper temperatures and due to their small size are conducive to situations that can result in cross contamination. Controlled processing is required for the safe preparation of food for sale to the public. FOOD SOURCE 1d HACCP plan not in place PUBLIC HEALTH SIGNIFICANCE Retail food establishments must have a Health Department approved Hazard Analysis Critical Control Point (HACCP) plan in place when vacuum packageing or when conducting other forms of modified oxygen packaging (MAP). Foods not properly processed using MAP techniques are prone to the growth of botulism. All MAP processed foods must be held refrigerated at 41oF or less until cooking or service. Shelf life of MAP foods are not to exceed 10 days. PERSONNEL 2e Smoking; eating; drinking not restricted PUBLIC HEALTH SIGNIFICANCE The use of tobacco products or eating or drinking during food preparation is prohibited. The hand to mouth contact that occurs during these activities results in the contamination of workers hands and food. SANITATION RINSE 4c In place PUBLIC HEALTH SIGNIFICANCE All equipment, utensils and food contact surfaces must be properly washed and then sanitized to minimize food contamination. Washing is the removal of food residue or soil from surfaces. Sanitization is the application of heat or chemicals on cleaned surfaces that results in a 99.999% reduction of disease-causing microorganisms. There are many different types of sanitizers that can be used in food establishments. The most common include: hot water between 165oF and 180oF, chlorine mixed at a concentration of 50 ppm, quaternary ammonia mixed at a concentration of 200 ppm, and iodine mixed at a concentration of 12.5 ppm. Establishments will often have equipment that needs to be washed and sanitized, but is too large to fit into warewashing sinks or dishmachines, or is not designed to be submerged in water. This equipment must be washed and sanitized “in place”. Surfaces must be washed with a detergent solution to remove food residue, then rinsed free of detergents with clean water and then sanitized with an approved sanitizer.
PEST CONTROL 7b Inappropriate pesticide application PUBLIC HEALTH SIGNIFICANCE Effective and approved measures must be taken to control insect, rodents, and other pests that may get into food establishments. Effective pest management includes: a) preventing entry of pests into the establishment by providing tight fitting doors and threshold, keeping outside door closed, and sealing off any cracks or openings in foundations or around utility penetrations. b) Depriving them of food, water and shelter by keeping the premises clean, free of the acclimation of refuse, garbage and food spills. c) Kill what gets in with the use of traps or pesticides. Only approved pesticides, registered for application in food establishments can be applied. All pesticides must be used according to label directions. Rodent baits must be contained and dispensed form closed, tamper proof bait stations. The use of open bait stations or tracking powder pesticides can result in the pesticides being dispersed throughout the food establishment and ultimately contaminating food and food contact surfaces. TESTING DEVICES 11c Chemical test kits not provided; inaccessible PUBLIC HEALTH SIGNIFICANCE The temperature of the wash and rinse water is a critical factor effecting cleaning and sanitizing of equipment and utensils. It is important that warewashing machines and high-temperature three-compartment warewashing sinks are therefore equipped with accurate thermometers to measure water temperatures. Sanitzer test kits must also be provided and used by food workers to ensure that the concentration of any chemical sanitizers being used are correct. Warewashing machines are required to operate at specific water flow pressures. Water flow pressure can greatly effect how well a dishmachine will sanitize. Low water flow pressure results in inadequate spray patterns and incomplete coverage of the equipment and utensils being washed. Excessive flow pressures will atomize water droplets and again result in incomplete coverage. A pressure gauge installed on the dishmachine’s final rinse line allows workers to monitor the water flow pressure of a dishmachine.
Restaurant representatives - add corrected or new information about PARY'S ON 28TH, 5021 E 28th Ave, Denver, CO »