- Critical. (A) Except as specified in Paragraph (D) of this section, refrigerated, ready-to-eat, potentially hazardous food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, based on the temperature and time combinations specified below: (1) 41 degrees Fahrenheit or less for a maximum of 7 days; The day of preparation shall be counted as Day 1.
- Critical. (A) Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under Section 3-501.19, and except as specified in Paragraph (B) of this section, potentially hazardous food shall be maintained: (1) At 135 degrees Fahrenheit or above, except that roasts cooked to a temperature and for a time specified in Paragraph 3-401.11(B) or reheated as specified in Paragraph 3-403.11(E) may be held at a temperature of 130 degrees Fahrenheit or above;
- Critical. (A) FOOD TEMPERATURE MEASURING DEVICES that are scaled only in Celsius or dually scaled in Celsius and Fahrenheit shall be accurate to plus or minus 1 degree Celsius in the intended range of use. (B) FOOD TEMPERATURE MEASURING DEVICES that are scaled only in Fahrenheit shall be accurate to plus or minus 2 degrees Fahrenheit in the intended range of use.
- Critical. (A) In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit. (B) Except as specified in Paragraph (C) of this section, cold or hot holding equipment used for potentially hazardous food shall be designed to include and shall be equipped with at least one integral or permanently affixed temperature measuring device that is located to allow easy viewing of the device's temperature display. (C) Paragraph (B) of this section does not apply to equipment for which the placement of a temperature measuring device is not a practical means for measuring the ambient air surrounding the food because of the design, type, and use of the equipment, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated food transport containers, and salad bars. (D) Temperature measuring devices shall be designed to be easily readable. (E) Food temperature measuring device and water temperature measuring device on warewashing machines shall have a numerical scale, printed record, or digital readout in increments no greater than 2 degrees Fahrenheit in the intended range of use.
- Critical. FOOD Storage. (A) Except as specified in Paragraphs (B) and (C) of this section, FOOD shall be protected from contamination by storing the FOOD: (1) In a clean, dry location; (2) Where it is not exposed to splash, dust, or other contamination; and (3) At least 6 inches above the floor. (B) FOOD in PACKAGES and working containers may be stored less than 6 inches above the floor on case lot handling EQUIPMENT as specified under Section 4-204.122. (C) Pressurized BEVERAGE containers, cased FOOD in waterproof containers such as bottles or cans, and milk containers in plastic crates may be stored on a floor that is clean and not exposed to floor moisture.
- Critical. (A) FOOD shall be protected from cross contamination by: (4) storing the FOOD in PACKAGES, covered containers, or wrappings;
- In-Use Utensils, Between-Use Storage. During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored: (E) In a clean, protected location if the utensils, such as ice scoops, are used only with a food that is not potentially hazardous;
- During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored: (A) Except as specified under Paragraph (B) of this section, in the food with their handles above the top of the food and the container; (B) In food that is not potentially hazardous with their handles above the top of the food within containers or equipment that can be closed, such as bins of sugar, flour, or cinnamon;
- Good Repair and Proper Adjustment. (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified in Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturers' specifications.
- (B) Cloths used for wiping FOOD spills shall be: (2) Wet and cleaned as specified under Paragraph 4-802.11(D), stored in a chemical sanitizer at a concentration specified in Section 4-501.114, and used for wiping spills from FOOD-CONTACT and nonFOOD-CONTACT SURFACES of EQUIPMENT.
- NonFOOD-CONTACT SURFACES of EQUIPMENT shall be cleaned at a frequency necessary to preclude accumulation of soil residues.
- (C) SINGLE-SERVICE and SINGLE-USE ARTICLES shall be stored as specified under Paragraph (A) of this section and shall be kept in the original protective PACKAGE or stored by using other means that afford protection from contamination until used. (D) Items that are kept in closed packages may be stored less than 6 inches above the floor on dollies, pallets, racks, and skids that are designed as provided under Section 4-204.122.
- (A) Except as specified in Paragraph (B) of this section, SINGLE-SERVICE and SINGLE-USE ARTICLES may not be stored: (1) In locker rooms; (2) In toilet rooms; (3) In garbage rooms; (4) In mechanical rooms; (5) Under sewer lines that are not shielded to intercept potential drips; (6) Under leaking water lines including leaking automatic fire sprinkler heads or under lines on which water has condensed; (7) Under open stairwells; or (8) Under other sources of contamination. (B) SINGLE-SERVICE and SINGLE-USE ARTICLES that are PACKAGED or in a facility such as a cabinet may be stored in a locker room.
- Critical. Backflow Prevention Device, When Required. A PLUMBING SYSTEM shall be installed to preclude backflow of a solid, liquid, or gas contaminant into the water supply system at each point of use at the FOOD ESTABLISHMENT, including on a hose bibb if a hose is attached or on a hose bibb if a hose is not attached and backflow prevention is required by LAW, by: (A) Providing an air gap as specified under Section 5-202.13; or (B) Installing an APPROVED backflow prevention device as specified under Section 5-202.14.
- Critical. (B) Using a Handwashing Facility. A handwashing lavatory may not be used for purposes other than handwashing.
- Critical. Hand Drying Provision. Each handwashing lavatory or group of adjacent lavatories shall be provided with: (A) Individual, disposable towels; (B) A continuous towel system that supplies the user with a clean towel; or (C) A heated-air hand drying device.
- (A) Cleaning, Frequency and Restrictions. The PHYSICAL FACILITIES shall be cleaned as often as necessary to keep them clean.
- (A) Cleaning, Frequency and Restrictions. The PHYSICAL FACILITIES shall be cleaned as often as necessary to keep them clean.
- Hoods, grease removal devices, fans, ducts, and other appurtenances shall be cleaned to bare metal prior to surfaces becoming heavily contaminated with grease or oily sludge. FOR REPORTING PURPOSES ONLY
- Light Bulbs, Protective Shielding. (A) Except as specified in Paragraph (B) of this section, light bulbs shall be shielded, coated, or otherwise shatter-resistant in areas where there is exposed FOOD; clean EQUIPMENT, UTENSILS, and LINENS; or unwrapped SINGLE-SERVICE and SINGLE-USE ARTICLES. (B) Shielded, coated, or otherwise shatter-resistant bulbs need not be used in areas used only for storing FOOD in unopened packages, if: (1) The integrity of the packages can not be affected by broken glass falling onto them; and (2) The packages are capable of being cleaned of debris from broken bulbs before the packages are opened. (C) An infrared or other heat lamp shall be protected against breakage by a shield surrounding and extending beyond the bulb so that only the face of the bulb is exposed.
- Critical. Separation. POISONOUS OR TOXIC MATERIALS shall be stored so they can not contaminate FOOD, EQUIPMENT, UTENSILS, LINENS, and SINGLE-SERVICE and SINGLE-USE ARTICLES by: (A) Separating the POISONOUS OR TOXIC MATERIALS by spacing or partitioning; and (B) Locating the POISONOUS OR TOXIC MATERIALS in an area that is not above FOOD, EQUIPMENT, UTENSILS, LINENS, and SINGLE-SERVICE or SINGLE-USE ARTICLES. This paragraph does not apply to EQUIPMENT and UTENSIL cleaners and sanitizers that are stored in WAREWASHING areas for availability and convenience if the materials are stored to prevent contamination of FOOD, EQUIPMENT, UTENSILS, LINENS, and SINGLE-SERVICE and SINGLE-USE ARTICLES.
- Drying Mops. After use, mops shall be placed in a position that allows them to air-dry without soiling walls, EQUIPMENT, or supplies.
- Any operator of a pubic food service establishment shall maintain the latest food service inspection report or a duplicate copy on premises and shall make it available to the public upon request. The operator of each public food service establishment shall maintain the latest inspection report on premises and shall make it available to any consumer who asks to see it.
- Critical. (1) Each licensed establishment shall have a minimum of one certified food protection manager responsible for all periods of operation.
- Critical. Food service employee training. The division shall adopt, by rule, minimum food safety protection standards for the training of all food service employees who are responsible for the storage, preparation, display, or serving of foods to the public in establishments regulated under this chapter. These standards shall not include an examination, but shall provide for a food safety training certificate program for food service employees to be administered by a private nonprofit provider chosen by the division. Any food safety training program established and administered to food handler employees prior to the effective date of this act shall be submitted by the operator to the division for its review and approval. It shall be the duty of the licensee of the public food service establishment to provide training in accordance with the described rule to all employees under the licensee's supervision or control. The licensee may designate a certified food service manager to perform this function as an agent of the licensee. Food service employees must receive certification pursuant to this section by January 1, 2001. Food service employees hired after November 1, 2000, must receive certification within 60 days after employment. Certification pursuant to this section shall remain valid for 3 years.
|
3/12/2010 | Routine - Food | Warning Issued |
Restaurant representatives - add corrected or new information about Jenny's Lunch Box, 295 N Magnolia Dr, Tallahassee, FL »